A 0 to 2.5 V DAC into a −3.0 to −1.5 V gate bias, on a 2.5 V reference, is 20 k, 7.5 k, 12 k and 10 k on E24, with 0 V error at both ends. The Rescaler wizard finds that from the two points; the next E24 set it lists is 6.6 mV off at full scale. Place it, and the gain and offset readout gives m = 0.6 V/V and b = −3 V, with the 22 ppm that the op-amp's A0 = 1e5 takes off both.
Ten templates solve on open: node voltages on the sheet, a DC sweep and a Bode plot. An output past a rail reads the rail and gets a red RAIL badge.
Gate-bias safety solves the gate with the reference, the input or a rail at 0 V: on the rescaler, the reference at 0 V puts +1.5 V on the gate at full scale.
Probe a net to read its voltage, or probe a wire to cut it and read its current.
Copy link puts the whole circuit in the link. Open in RF Schematic Simulator opens the same circuit there.
Solved examples: a level shifter, an offset amplifier into an ADC and a 1 kHz Sallen-Key, each with its parts and numbers.
Start from a template
Each one opens with its sources, a DC sweep and an AC sweep, and solves at once. Your current sheet stays in File, Recent.
Gate bias
The rescaler on a gate, with the gate-bias safety table and the gate's window shaded on the DC sweep.