Sallen-Key low pass filter design for 1 kHz on E24: 7.5 kΩ, 30 nF and 15 nF give 1000.4 Hz, Q 0.7071

Two 7.5 kΩ resistors with C1 = 30 nF from their junction to the output and C2 = 15 nF to ground make a unity-gain Butterworth low-pass at f0 = 1000.4 Hz and Q = 0.7071, +0.04% from 1 kHz with every part on E24. With a 1 MHz GBW op-amp (A0 = 1e5) the engine's H(s) puts the pair at 999.6 Hz with Q = 0.7076, and the op-amp's own pole at 1.001 MHz.

How the parts were picked: equal resistors and C1 = 2·C2 fix Q at 1/√2 for any R, so only f0 is left to place. Of every E24 R from 1 kΩ to 91 kΩ and every E24 capacitor pair from 1 nF to 91 nF, this set lands closest to 1 kHz, and the larger capacitors win a tie.

Open in Op-Amp Lab

Change this: set R1 and R2 to 15 kΩ and f0 drops to 500.2 Hz; Q stays 0.7071, since it depends on C1/C2 alone.

Key numbers

QuantityIdeal op-ampA0 1e5, GBW 1 MHz
f01000.4 Hz999.6 Hz
f0 error from 1 kHz+0.04%−0.04%
Q0.70710.7076
Q error from 1/√2+0.00%+0.07%
Op-amp polenone1.001 MHz
DC gain10.999990 V/V

Every result here is the Op-Amp Lab's own, computed when the site was built from the circuit the button opens, and checked against a hand calculation. How the engine is checked.

The circuit

H(s) = 1/(1 + s·C2·(R1 + R2) + s²·R1·R2·C1·C2)

PartValueWhere
R17.5 kΩInput to the junction
R27.5 kΩJunction to the + input
C130 nFJunction to the output
C215 nF+ input to ground

The engine's H(s) includes the op-amp's A0 and GBW. It leaves out output resistance, slew rate and the capacitors' tolerance.

Other solved op-amp circuits

Question about this circuit, or a correction?