IndieRF Link Budget Calculator
Link budget and range calculator
5 km at 915 MHz is 105.7 dB of free-space path loss. A 22 dBm LoRa radio with 2 dBi antennas lands at −79.7 dBm, 57 dB above the SX1262's −137 dBm SF12 sensitivity. Type your radio, antennas, cables, and distance, then check the transmit power against the US 15.247 limits.
US check: 47 CFR 15.247 transmit power
Within the limit. +22.0 dBm conducted is 8.0 dB under the +30.0 dBm limit for a 2 dBi antenna.
15.247(b)(2) sets 1 W (30.0 dBm) of conducted output in 902 to 928 MHz. Antennas up to 6 dBi take no reduction (15.247(b)(4)). EIRP ceiling with this antenna: +32.0 dBm.
A 125 kHz LoRa signal is narrower than the 500 kHz minimum 6 dB bandwidth for digital modulation in 15.247(a)(2). As a frequency-hopping system in 902 to 928 MHz with a 20 dB bandwidth under 250 kHz, it needs at least 50 channels for the 1 W limit ((a)(1)(i), (b)(2)).
This compares the power at the radio port with the conducted limit and does not credit cable loss. It checks power and antenna gain only: bandwidth, dwell time, power spectral density (15.247(e)), and RF exposure are not checked. Outside the US, check your local rules. Read 47 CFR 15.247 on eCFR.
Where the free-space number stops
A 22 dBm SX1262 with 2 dBi antennas at each end has 57.3 dB of margin at 5 km and 915 MHz in free space. SF12 reaches 3,683 km on paper and SF7 824 km. No ground link gets there. Each doubling of distance costs 6.02 dB, and terrain, trees, a Fresnel zone cut by the ground, and the hand holding the radio all add loss that free space leaves out. Put that budget in the fade margin field. 30 dB, the Rayleigh allowance for 99.9% of the time with no line of sight, brings SF12 down to 116 km.
Two radios on 2 m masts see each other out to 11.7 km, the radio horizon over a 4/3 earth, so the horizon sets the range long before free space does. Halfway along a 5 km path at 915 MHz the first Fresnel zone is 20.2 m in radius. Over flat ground on 2 m masts, nearly half of it is below the surface, one more reason ground links fall short of the free-space number. The calculator starts on 2 m masts at both ends. Clear a height to drop the horizon, or type your own. How far a LoRa or Meshtastic node reaches, with the mast height that moves the horizon and the two-ray and 3GPP paths beside it: LoRa and Meshtastic range.
SF12 buys 13 dB over SF7, a factor of 4.5 in free-space range. It pays in airtime: a LoRa symbol lasts 2^SF/BW, so an SF12 symbol is 32 times longer than an SF7 one.
Sources
- Semtech SX1261/2 data sheet DS.SX1261-2.W.APP, Rev. 1.2, June 2019, Table 3-8, RXS_LB (Rx boosted gain, split RF paths, RF switch loss excluded). Typical, 1% PER, 64-byte packet, CR 4/5, CRC on, explicit header (section 3.5).
- Semtech SX1261/2 data sheet DS.SX1261-2.W.APP, Rev. 1.2, June 2019, Table 6-1, typical LoRa demodulator SNR. SNR at the receiver input the demodulator needs, per SF.
- Semtech SX1276/77/78/79 data sheet, Rev. 5, August 2016, Table 10, RFS_L125_HF, RFS_L250_HF and RFS_L500_HF (Band 1, highest LNA gain, LnaBoost, split Rx/Tx path). Typical, 1% PER, 64-byte payload, CR 4/6, CRC on, 3.3 V, 25 °C (section 2.5.5).
- Semtech SX1276/77/78/79 data sheet, Rev. 5, August 2016, Table 13, LoRa demodulator SNR. SNR at the receiver input the demodulator needs, per SF.
- Meshtastic documentation, Radio Settings, read 2026-10-31, Presets table (SF, coding rate, bandwidth). Modem settings per preset; no sensitivity is printed.
- Nordic nRF52840 Product Specification 4413_417, v1.1, 2019-02-28, Section 6.20.15.5, Receiver operation (PSENS rows). Typical, ideal transmitter; 1M at a 37-byte packet and BER 1E-3, 2M at a 37-byte packet.
- Bluetooth Core Specification, v6.0, Vol 6, Part A, section 4.1, Table 4.2 (receiver sensitivity per PHY). Required: the actual sensitivity must be this level or better, at the BER of Table 4.1 (0.1% for payloads up to 37 bytes).
- Nordic nRF52840 Product Specification 4413_417, v1.1, 2019-02-28, Section 6.20.15.5, Receiver operation (PSENS,IEEE 802.15.4). Typical, IEEE 802.15.4 mode.
- Espressif ESP32-C6 Series Datasheet, v1.5, 2026-03-31, Table 6-4, RX Sensitivity. Typical, 10% PER for 802.11g/n/ax and 8% for 802.11b (section 6.1.2).
- Motorola Solutions MOTOTRBO CP200d data sheet, 06-2020, Receiver: Analog Sensitivity (12 dB SINAD) and Digital Sensitivity (5% BER). Typical; µV into 50 Ω, converted to dBm with P = V²/R and stored to 0.1 dB. The sheet gives 12.5 and 25 kHz channels but does not tie either sensitivity to one.
- 3GPP TS 36.101 (ETSI TS 136 101), V16.7.0 (2020-12), Release 16, Table 7.3.1-1 Reference sensitivity QPSK PREFSENS, 10 MHz column. Minimum requirement, per antenna port of a two-port UE, QPSK, throughput at least 95% of maximum (7.3.1). Transmit power class from Table 6.2.2-1; downlink band edges from Table 5.5-1.
- The SX1262 table prints SF7 (−124 dBm) and SF12 (−137 dBm) only, so SF8 to SF11 come from the SX1276 table. The 802.11 and 802.15.4 minimum sensitivities are not shown: no primary copy of either standard was read.
- Transmit power limits: 47 CFR 15.247, paragraphs (a), (b), and (c)(1), read on eCFR on 31 October 2026.
- Analog FPV: 47 CFR 15.249(a) and (c). The FPV preset values are assumptions; put in your own transmitter and receiver.
Checked against a Python Friis reference: the cases, the tolerance and what the check does not cover.