Bias tee design calculator: 0.05 dB loss at 1.575 GHz, DC port 46.4 dB down

A 27 pF DC block and a 39 nH choke feed 3.3 V up the coax to a GPS L1 active antenna with 0.046 dB of RF loss at 1.575 GHz, S11 at -27.4 dB, and the DC port 46.4 dB below the RF path. The DC run on the same sheet reads 14.97 mA from the supply and 3.294 V at the antenna.

Open in the simulator

Change this: halve L1 to 19.5 nH. The DC port isolation at 1.575 GHz drops from 46.4 dB to 40.5 dB.

-60-40-2000.511.522.53GHzdB
S21S11S31Circles mark the table's numbers.
QuantityValueRead at
S21, RF in to RF and DC out-0.046 dB1.575 GHz
S11, RF in-27.43 dB1.575 GHz
S31, RF in to the DC port-46.43 dB1.575 GHz
S31 with L1 19.5 nH-40.49 dB1.575 GHz
DC feed current from 3.3 V14.97 mADC
DC voltage at the antenna3.294 VDC

Every number here is the simulator's own, computed when the site was built from the same circuit the button opens. How the engine is checked.

The circuit

P1Z=50C1C=27pL1L=39nQ=50C2C=100pGND1VVOUTDCF1R1R=220GND2DCB1P2Z=50DCB2P3Z=50DCF2AIFEEDV1V=3.3GND3

How the DC load is modelled

A port is 50 ohm to ground in the DC run, so P2 and P3 each sit behind an ideal DC block (a through at every frequency above zero, an open at DC). The antenna's DC draw is R1, 220 ohm, and the 3.3 V supply is V1; each hangs off an ideal DC feed (an open above zero, a wire at DC). In the S sweep the ports see the tee and nothing else. At DC the supply feeds R1 through L1's 0.4 ohm of DC resistance and no current flows into a port, so the 14.97 mA and 3.294 V the run reads are V / (Rdc + R1) and V R1 / (Rdc + R1).

Typical part values with Q, ESR, ESL and SRF (L1 Q 50 at 1.575 GHz, SRF 2.6 GHz), not one vendor's part. Pads, traces and the coax are left out.

Other solved examples

Question about this circuit, or a correction?