ESP32-S3 Antenna Matching: 35 Ω Target and CLC Ranges
Espressif's target for the ESP32-S3 RF pin is 35+j0 Ω: S11 of the matching circuit, measured from the chip end, should sit close to that chip conjugate point. The reference network is a CLC pi with C12 1.8 ~ 1.2 pF at the chip, L2 2.0 ~ 3.0 nH in series and C11 1.2 ~ 1.8 pF toward the 50 Ω antenna trace.
Target at the chip end: 35 Ω (printed 35+j0)
“If S11 is close to the chip conjugate point 35+j0 and S21 is less than -35 dB at 4.8 GHz and 7.2 GHz, the matching circuit can satisfy transmission requirements.”
Read as S11 at port 1 of the matching circuit, the port near the chip, on a network analyzer. ESP32-S3 Hardware Design Guidelines v1.8 (2025-07-03), Schematic Checklist, RF Tuning, page 12.
Open in Match with 35 Ω at the chip and a 50 Ω trace
Espressif prints no frequency with the target, so Match opens at its 2.45 GHz default. Type your channel in f0 and Match redraws the L-network.
Chip matching circuit (CLC)
Value ranges for a PCB that follows the guide's PCB Layout Design chapter. 0201 parts. C12 shunt at the chip pin, L2 in series, C11 shunt toward the antenna.
| Part | Value as printed | Place | Maker part |
|---|---|---|---|
| C11 | 1.2 ~ 1.8 pF | Shunt, antenna side of L2 | GRM0335C1H1RXBA01D |
| L2 | 2.0 ~ 3.0 nH | Series | LQP03TN2NXB02D |
| C12 | 1.8 ~ 1.2 pF | Shunt at the chip pin (LNA_IN) | GRM0335C1H1RXBA01D |
ESP32-S3 Hardware Design Guidelines v1.8 (2025-07-03): Figure 7 (ESP32-S3 Schematic for RF Matching) and Table 6 (Recommended Value Ranges for Components), page 12.
Gaps in the source
- Espressif prints value ranges, not one value per part, and marks every part TBD on the schematic.
- No design frequency is printed with the target. The harmonic limits are at 4.8 GHz and 7.2 GHz, twice and three times 2.4 GHz.
- Table 6 prints the C12 range as 1.8 ~ 1.2 pF, high value first. The page copies it as printed.
Other printed numbers
- S21 less than −35 dB at 4.8 GHz and 7.2 GHz (ESP32-S3 Hardware Design Guidelines v1.8 (2025-07-03), Schematic Checklist, RF Tuning, page 12)
- Add a stub to the ground pad of the first capacitor at the chip end (ESP32-S3 Hardware Design Guidelines v1.8 (2025-07-03), Figure 7 and the note under Table 6, page 12)
Sources
- ESP32-S3 Hardware Design Guidelines, v1.8, 2025-07-03, read 2026-11-12
Other chips
L-network calculatorQuestion about this chip, or a correction?