PCBWay 4-layer 1.2 mm 70% stackup: layers, εr, 50 Ω and 90 Ω widths

PCBWay 4-layer 1.2 mm 70% is PCBWay's 1.2 mm 4-layer structure for 70% inner residual copper: 0.1855 mm of 7628 prepreg, RC46% at εr 4.74 under layer 1, over a 0.630 mm core. A 50 Ω microstrip on layer 1 is 12.08 mil (0.307 mm) with no solder mask, because PCBWay does not print one, at 1 GHz.

Open PCBWay 4-layer 1.2 mm 70% in the Transmission Line Calculator

Layers

LayerMaterialThicknessεrCopper
MaskSolder maskNot printedNot printed
L1Copper0.0350 mm1 oz finished
L1 to L27628 prepreg, RC46%0.1855 mm4.74
L2Copper0.0350 mm1 oz
L2 to L3core0.630 mm4.6
L3Copper0.0350 mm1 oz
L3 to L47628 prepreg, RC46%0.1855 mm4.74
L4Copper0.0350 mm1 oz finished
MaskSolder maskNot printedNot printed

After lamination the 7628 between layer 1 and layer 2 is 0.1855 mm on the 70% residual-copper row. The glass before press is 0.1960 mm. This is the 70% inner residual-copper row. PCBWay prints 70%, 50% and 30% rows and says to use the 70% row above 60% and the 30% row at 40% or less. PCBWay does not state the frequency for this DK.

Trace widths on layer 1

LineWidthSolvedCalculator
50 Ω microstrip, mask off12.08 mil (0.307 mm)50.00 ΩOpen
90 Ω pair, 5 mil gap, mask off8.66 mil (0.220 mm)90.00 ΩOpen
100 Ω pair, 5 mil gap, mask off6.56 mil (0.167 mm)100.00 ΩOpen

Bare copper at 1 GHz, from a 2-D field solve of the cross-section with no solder mask. PCBWay does not print a mask thickness or εr, and its own impedance calculator leaves the mask out, so these widths are mask off. The 5 mil gap is a typed value, because the stackup leaves the gap to you. Ask the fab what space it will etch, then open the row and type that.

What PCBWay does not print

No typical number fills these, and none of them sets a width on this page.

The same 50 Ω line on the other PCBWay 4-layer builds

The prepreg under layer 1 sets the width. A thinner prepreg gives a narrower line for the same impedance, and builds with the same prepreg under layer 1 give the same width.

Sources

How IndieRF checks its numbers: each engine against an outside answer, with the tolerance and what it does not cover.

KiCad vs JLCPCB 50 Ω width90 Ω USB pair width50 Ω microstrip width on FR-4Question about this stackup, or a correction?