JLC04161H-1080B stackup: layers, εr, 50 Ω and 90 Ω widths

JLC04161H-1080B is JLCPCB's 1.6 mm 4-layer build: 0.2444 mm of 1080 prepreg in three plies at εr 3.91 under layer 1, over a 1.065 mm core. A 50 Ω microstrip on layer 1 is 17.92 mil (0.455 mm) with the solder mask at 1 GHz.

Open JLC04161H-1080B in the Transmission Line Calculator

Layers

LayerMaterialThicknessεrCopper
MaskSolder mask0.6 mil3.8
L1Copper1.6 mil1 oz finished
L1 to L21080 prepreg0.084 + 0.084 + 0.0764 mm (0.2444 mm)3.91
L2Copper0.0152 mm0.5 oz
L2 to L3core1.065 mm4.6
L3Copper0.0152 mm0.5 oz
L3 to L41080 prepreg0.084 + 0.084 + 0.0764 mm (0.2444 mm)3.91
L4Copper1.6 mil1 oz finished
MaskSolder mask0.6 mil3.8

Three 1080 plies on the stackup drawing: 0.084 mm, 0.084 mm, 0.0764 mm. JLCPCB gives no pressed thickness for this build, so the height is their sum, 0.2444 mm. JLCPCB does not state the frequency for this εr.

Trace widths on layer 1

LineWidthSolvedCalculator
50 Ω microstrip, with mask17.92 mil (0.455 mm)50.00 ΩOpen
50 Ω microstrip, mask off18.66 mil (0.474 mm)50.00 ΩOpen
90 Ω pair, 5 mil gap, with mask10.23 mil (0.260 mm)90.00 ΩOpen
100 Ω pair, 5 mil gap, with mask7.33 mil (0.186 mm)100.00 ΩOpen

Bare copper at 1 GHz, from a 2-D field solve of the cross-section with the mask coating the trace top and sidewalls. The 5 mil gap is a typed value, because the stackup leaves the gap to you. Ask the fab what space it will etch, then open the row and type that. JLCPCB's guide says the etched top width is the base width minus 0.7 mil. These widths do not subtract it, so let the coupon decide the last ohm.

The same 50 Ω line on the other 1.6 mm 4-layer builds

The prepreg under layer 1 sets the width. A thinner prepreg gives a narrower line for the same impedance, and builds with the same prepreg under layer 1 give the same width.

Sources

How IndieRF checks its numbers: each engine against an outside answer, with the tolerance and what it does not cover.

KiCad vs JLCPCB 50 Ω width90 Ω USB pair width50 Ω microstrip width on FR-4Question about this stackup, or a correction?