JLC04161H-7628C stackup: layers, εr, 50 Ω and 90 Ω widths

JLC04161H-7628C is JLCPCB's 1.6 mm 4-layer build: 0.6464 mm of 7628 prepreg in three plies at εr 4.4 under layer 1, over a 0.15 mm core. A 50 Ω microstrip on layer 1 is 46.14 mil (1.172 mm) with the solder mask at 1 GHz.

Open JLC04161H-7628C in the Transmission Line Calculator

Layers

LayerMaterialThicknessεrCopper
MaskSolder mask0.6 mil3.8
L1Copper1.6 mil1 oz finished
L1 to L27628 prepreg0.218 + 0.218 + 0.2104 mm (0.6464 mm)4.4
L2Copper0.0152 mm0.5 oz
L2 to L3core0.15 mm4.6
L3Copper0.0152 mm0.5 oz
L3 to L47628 prepreg0.218 + 0.218 + 0.2104 mm (0.6464 mm)4.4
L4Copper1.6 mil1 oz finished
MaskSolder mask0.6 mil3.8

Three 7628 plies on the stackup drawing: 0.218 mm, 0.218 mm, 0.2104 mm. JLCPCB gives no pressed thickness for this build, so the height is their sum, 0.6464 mm. An older JLCPCB impedance page still lists 7628 as 4.6. This preset uses 4.4 from the current stackup page and the capabilities table. JLCPCB does not state the frequency for this εr.

Trace widths on layer 1

LineWidthSolvedCalculator
50 Ω microstrip, with mask46.14 mil (1.172 mm)50.00 ΩOpen
50 Ω microstrip, mask off46.95 mil (1.192 mm)50.00 ΩOpen
90 Ω pair, 5 mil gap, with mask13.36 mil (0.339 mm)90.00 ΩOpen
100 Ω pair, 5 mil gap, with mask8.61 mil (0.219 mm)99.99 ΩOpen

Bare copper at 1 GHz, from a 2-D field solve of the cross-section with the mask coating the trace top and sidewalls. The 5 mil gap is a typed value, because the stackup leaves the gap to you. Ask the fab what space it will etch, then open the row and type that. JLCPCB's guide says the etched top width is the base width minus 0.7 mil. These widths do not subtract it, so let the coupon decide the last ohm.

The same 50 Ω line on the other 1.6 mm 4-layer builds

The prepreg under layer 1 sets the width. A thinner prepreg gives a narrower line for the same impedance, and builds with the same prepreg under layer 1 give the same width.

Sources

How IndieRF checks its numbers: each engine against an outside answer, with the tolerance and what it does not cover.

KiCad vs JLCPCB 50 Ω width90 Ω USB pair width50 Ω microstrip width on FR-4Question about this stackup, or a correction?