JLC06161H-1080 stackup: layers, εr, 50 Ω and 90 Ω widths

JLC06161H-1080 is JLCPCB's 1.6 mm 6-layer build: 0.0764 mm of 1080 prepreg at εr 3.91 under layer 1, over a 0.55 mm core. A 50 Ω microstrip on layer 1 is 4.69 mil (0.119 mm) with the solder mask at 1 GHz.

Open JLC06161H-1080 in the Transmission Line Calculator

Layers

LayerMaterialThicknessεrCopper
MaskSolder mask0.6 mil3.8
L1Copper1.6 mil1 oz finished
L1 to L21080 prepreg0.0764 mm3.91
L2Copper0.0152 mm0.5 oz
L2 to L3core0.55 mm4.6
L3Copper0.0152 mm0.5 oz
L3 to L47628 prepreg8.5 mil4.4
L4Copper0.0152 mm0.5 oz
L4 to L5core0.55 mm4.6
L5Copper0.0152 mm0.5 oz
L5 to L61080 prepreg0.0764 mm3.91
L6Copper1.6 mil1 oz finished
MaskSolder mask0.6 mil3.8

The stackup drawing lists 0.0764 mm. JLCPCB does not give a separate pressed thickness for this 1080 outer layer. JLCPCB does not state the frequency for this εr.

Trace widths on layer 1

LineWidthSolvedCalculator
50 Ω microstrip, with mask4.69 mil (0.119 mm)50.00 ΩOpen
50 Ω microstrip, mask off5.26 mil (0.134 mm)50.00 ΩOpen
90 Ω pair, 5 mil gap, with mask4.14 mil (0.105 mm)90.00 ΩOpen
100 Ω pair, 5 mil gap, with mask3.11 mil (0.079 mm)under JLCPCB's 3.5 mil minimum100.00 ΩOpen

Bare copper at 1 GHz, from a 2-D field solve of the cross-section with the mask coating the trace top and sidewalls. The 5 mil gap is a typed value, because the stackup leaves the gap to you. Ask the fab what space it will etch, then open the row and type that. JLCPCB's guide says the etched top width is the base width minus 0.7 mil. These widths do not subtract it, so let the coupon decide the last ohm. JLCPCB's impedance page prints 3.5 mil as the minimum trace width and spacing (read 2026-11-12). A flagged row is under it.

The same 50 Ω line on the other 1.6 mm 6-layer builds

The prepreg under layer 1 sets the width. A thinner prepreg gives a narrower line for the same impedance, and builds with the same prepreg under layer 1 give the same width.

Sources

How IndieRF checks its numbers: each engine against an outside answer, with the tolerance and what it does not cover.

KiCad vs JLCPCB 50 Ω width90 Ω USB pair width50 Ω microstrip width on FR-4Question about this stackup, or a correction?