JLC06161H-2116B stackup: layers, εr, 50 Ω and 90 Ω widths

JLC06161H-2116B is JLCPCB's 1.6 mm 6-layer build: 0.1164 mm of 2116 prepreg at εr 4.16 under layer 1, over a 0.5 mm core. A 50 Ω microstrip on layer 1 is 7.39 mil (0.188 mm) with the solder mask at 1 GHz.

Open JLC06161H-2116B in the Transmission Line Calculator

Layers

LayerMaterialThicknessεrCopper
MaskSolder mask0.6 mil3.8
L1Copper1.6 mil1 oz finished
L1 to L22116 prepreg0.1164 mm4.16
L2Copper0.0152 mm0.5 oz
L2 to L3core0.5 mm4.6
L3Copper0.0152 mm0.5 oz
L3 to L41080 prepreg0.0764 + 0.0764 mm (0.1528 mm)3.91
L4Copper0.0152 mm0.5 oz
L4 to L5core0.5 mm4.6
L5Copper0.0152 mm0.5 oz
L5 to L62116 prepreg0.1164 mm4.16
L6Copper1.6 mil1 oz finished
MaskSolder mask0.6 mil3.8

The stackup drawing lists 0.1164 mm. JLCPCB does not give a separate pressed thickness for this 2116 outer layer. An older JLCPCB impedance page still lists 2116 as 4.25. This preset uses 4.16 from the current stackup page and the capabilities table. JLCPCB does not state the frequency for this εr.

Trace widths on layer 1

LineWidthSolvedCalculator
50 Ω microstrip, with mask7.39 mil (0.188 mm)50.00 ΩOpen
50 Ω microstrip, mask off8.00 mil (0.203 mm)50.00 ΩOpen
90 Ω pair, 5 mil gap, with mask5.71 mil (0.145 mm)90.00 ΩOpen
100 Ω pair, 5 mil gap, with mask4.24 mil (0.108 mm)100.00 ΩOpen

Bare copper at 1 GHz, from a 2-D field solve of the cross-section with the mask coating the trace top and sidewalls. The 5 mil gap is a typed value, because the stackup leaves the gap to you. Ask the fab what space it will etch, then open the row and type that. JLCPCB's guide says the etched top width is the base width minus 0.7 mil. These widths do not subtract it, so let the coupon decide the last ohm.

The same 50 Ω line on the other 1.6 mm 6-layer builds

The prepreg under layer 1 sets the width. A thinner prepreg gives a narrower line for the same impedance, and builds with the same prepreg under layer 1 give the same width.

Sources

How IndieRF checks its numbers: each engine against an outside answer, with the tolerance and what it does not cover.

KiCad vs JLCPCB 50 Ω width90 Ω USB pair width50 Ω microstrip width on FR-4Question about this stackup, or a correction?