2.4 GHz chip-antenna receiver: 8.00 dB NF and −94.0 dBm sensitivity
A 0.5 dB matching network and a 1.5 dB band-pass filter ahead of a 6 dB NF radio give 8.00 dB NF, so a 1 MHz channel meets 12 dB SNR at −94.0 dBm at the antenna feed. The −2 dBi chip antenna moves the signal and leaves the NF alone: a −90 dBm packet arrives at 14.0 dB SNR.
Change this: a 0.8 dB filter in place of the 1.5 dB one. NF reads 7.30 dB, and sensitivity improves by the same 0.70 dB.
NF 8.00 dB: Radio receiver, NF 6 dB, 30 dB gain sets it, 6.00 dB better if ideal, 89% of the excess noise.
IIP3 −8.00 dBm: Radio receiver, NF 6 dB, 30 dB gain is the only rated stage.
Block diagram
Level diagram
Budget at Radio receiver, NF 6 dB, 30 dB gain
| Row | Value |
|---|---|
| Cumulative Gain | 28.00 dB |
| Source Contribution | −64.00 dBm |
| Cumulative NF | 8.00 dB |
| SNR | 13.98 dB |
| Noise Density | −137.98 dBm/Hz |
| Total Noise Power | −77.98 dBm |
| Noise Floor (Input) | −105.98 dBm |
| Sensitivity at Required SNR (Input) | −93.98 dBm |
| P1dB Headroom | 74.00 dB |
| Cumulative OIP3 | 20.00 dBm |
| Cumulative IIP3 | −8.00 dBm |
| Cumulative OP1dB | 9.00 dBm |
| Cumulative IP1dB | −18.00 dBm |
| First Stage to Compress OP1dB | 9.00 dBm |
| SFDR | 65.32 dB |
| Spur-Free Dynamic Range (from Sensitivity) | 53.32 dB |
| Linear Dynamic Range | 87.98 dB |
| IM3 | −232.00 dBm |
| Cumulative Noise + Distortion Ratio | 13.98 dB |
| Fully Linear Power | −64.00 dBm |
| Local Compression | 0.00 dB |
| Cumulative Compression | 0.00 dB |
Every number here is the analyzer's own, solved when the site was built from the same template the button opens. How the solver is checked.
Where each value comes from
| Part | Value | Source |
|---|---|---|
| Signal | −90 dBm at 2.44 GHz in 1 MHz | Illustrative: a weak 1 Mbps packet near the edge of range. 1 MHz is the channel a 1 Mbps GFSK radio demodulates. |
| Chip antenna | −2 dBi | Illustrative: a chip antenna's gain depends on the ground plane and enclosure it sits in, so measure yours. Antenna gain moves the signal, not the system NF. |
| Matching network | 0.5 dB loss | Illustrative: a pi network of 0402 parts that tunes the chip antenna on the board. The loss depends on the parts' Q and how far the board detunes the antenna. |
| Band-pass filter | 1.5 dB loss | Illustrative: a small 2.45 GHz ceramic band-pass filter. Use the maximum insertion loss from your filter's datasheet. |
| Radio receiver | NF 6 dB, 30 dB gain, OIP3 +20 dBm, OP1dB +9 dBm | Illustrative: an integrated 2.4 GHz radio taken as one stage. Radio datasheets print sensitivity, not NF; 6 dB is what a sensitivity of about −96 dBm at 12 dB SNR in 1 MHz implies at the pin. |
| Required SNR | 12 dB | Illustrative: the order of SNR a 1 Mbps GFSK demodulator needs for 0.1% bit errors. Your radio's printed sensitivity already includes its own. |
Model limits
- The solver is unidirectional and matched: no mismatch interaction, return-loss cascade or stability.
- Noise density, NF, compression, gain and IM3 are read at each block's stage frequency, not solved across the operating band.
- A filter or any part with a frequency curve shapes noise inside the selected channel only: integrated noise, SNR and the noise floor integrate the curve across the channel, and Noise Density and NF stay spot values at its centre. A part with no curve is a scalar loss and NF. Noise outside the channel, such as an ADC's alias zones, is not counted.
- Distortion is IM3 only, and IM3 is not frequency resolved.
- Compression is a memoryless AM/AM curve: no AM/PM, bias or memory effects. Noise keeps the small-signal gain under a blocker.
Other solved chains
- 2.45 GHz superheterodyne receiver: 3.36 dB NF and −85.4 dBm sensitivity
- Direct-sampling SDR receiver at 1.2 GHz: 4.45 dB NF with 18.8 dB of ADC headroom
- LoRa 915 MHz receiver front end: 4.66 dB NF with an LNA after the filter
- ADS-B 1090 MHz receiver, filter first: 4.99 dB NF
- ADS-B 1090 MHz receiver, LNA first: 2.65 dB NF
- 28 GHz 5G transmitter lineup: 44.5 dBm EIRP with 8.7 dB P1dB headroom
- Ka-band 28.5 GHz transmitter lineup: 57.1 dBm EIRP with 6.2 dB P1dB headroom
- 2-way Wilkinson power-combining PA at 2.2 GHz: 36.5 dBm out, OIP3 51.0 dBm