LoRa 915 MHz receiver front end: 4.66 dB NF with an LNA after the filter

A 1.5 dB antenna cable, a 2 dB band-pass filter, an 18 dB LNA and a 6 dB NF transceiver cascade to 4.66 dB NF and 34.5 dB gain. In 125 kHz the input noise floor is −118.3 dBm, so the −120 dBm node arrives at −1.7 dB SNR; LoRa demodulates below the noise, and this budget stops at the transceiver input.

Open in the analyzer

Change this: a shorter antenna cable, 0.5 dB instead of 1.5 dB. NF reads 3.66 dB, since loss ahead of the LNA comes off the NF one for one.

NF 4.66 dB: Band-pass 915 MHz, 2 dB loss sets it, 1.44 dB better if ideal, 43% of the excess noise.

IIP3 15.50 dBm: LNA, NF 1 dB, 18 dB gain, OIP3 30 dBm is the only rated stage.

Block diagram

915 MHz antenna,−120 dBm nodeAntenna cable,1.5 dB lossBand-pass 915MHz, 2 dB lossLNA, NF 1 dB, 18dB gain, OIP3 30dBmLoRatransceiver, NF6 dB, 20 dB gain

Level diagram

−150−100−50050100dBm915 MHz antenn…Antenna cable,…Band-pass 915 …LNA, NF 1 dB, …LoRa transceiv…
Carrier in channelNoise in channelCumulative OP1dBCumulative OIP3Output referred, after each block.

Budget at LoRa transceiver, NF 6 dB, 20 dB gain

RowValue
Cumulative Gain34.50 dB
Source Contribution−85.50 dBm
Cumulative NF4.66 dB
SNR−1.65 dB
Noise Density−134.82 dBm/Hz
Total Noise Power−83.85 dBm
Noise Floor (Input)−118.35 dBm
P1dB Headroom124.50 dB
Cumulative OIP350.00 dBm
Cumulative IIP315.50 dBm
Cumulative OP1dB38.00 dBm
Cumulative IP1dB4.50 dBm
First Stage to Compress OP1dB38.00 dBm
SFDR89.23 dB
Linear Dynamic Range122.85 dB
IM3−356.50 dBm
Cumulative Noise + Distortion Ratio−1.65 dB
Fully Linear Power−85.50 dBm
Local Compression0.00 dB
Cumulative Compression0.00 dB

Every number here is the analyzer's own, solved when the site was built from the same template the button opens. How the solver is checked.

Model limits

Other solved chains

Question about this chain, or a correction?