Direct-sampling SDR receiver at 1.2 GHz: 4.45 dB NF with 18.8 dB of ADC headroom

Preselector, limiter, LNA, a 6 dB step attenuator and a VGA in front of a 3 GSPS ADC give 4.45 dB NF and 20.2 dB gain. The −35 dBm carrier lands at −18.8 dBFS, 18.8 dB below clipping, and the 200 MHz channel reaches 8 dB SNR at −68.7 dBm.

Open in the analyzer

Change this: the step attenuator from 6 to 0 dB. NF drops to 3.53 dB and the carrier moves 6 dB closer to ADC full scale.

NF 4.45 dB: Wideband LNA sets it, 0.96 dB better if ideal, 31% of the excess noise.

IIP3 8.83 dBm: Wideband VGA sets it, 14.17 dB better if ideal, 96% of 1/IIP3.

Block diagram

Wideband RFInputWidebandPreselectorADC ProtectionLimiterWideband LNADigital StepAttenuatorWideband VGAAnti-Alias LPF3 GSPS RF ADC

Level diagram

−100−50050dBmWideband RF In…Wideband Prese…ADC Protection…Wideband LNADigital Step A…Wideband VGAAnti-Alias LPF3 GSPS RF ADC
Carrier in channelNoise in channelCumulative OP1dBCumulative OIP3Output referred, after each block.

Budget at 3 GSPS RF ADC

RowValue
Cumulative Gain20.20 dB
Source Contribution−14.80 dBm
Cumulative NF4.45 dB
SNR41.72 dB
Noise Density−139.53 dBm/Hz
Total Noise Power−56.52 dBm
Noise Floor (Input)−76.72 dBm
Sensitivity at Required SNR (Input)−68.72 dBm
P1dB Headroom31.53 dB
Cumulative OIP329.03 dBm
Cumulative IIP38.83 dBm
Cumulative OP1dB15.73 dBm
Cumulative IP1dB−3.47 dBm
First Stage to Compress OP1dB16.20 dBm
SFDR56.20 dB
IM3−102.46 dBm
Cumulative Noise + Distortion Ratio41.57 dB
Fully Linear Power−14.80 dBm
Local Compression0.00 dB
Cumulative Compression0.00 dB
ADC Input Level−18.80 dBFS
ADC Clipping Margin18.80 dB
ADC Effective ENOB6.64 bits

Every number here is the analyzer's own, solved when the site was built from the same template the button opens. How the solver is checked.

Model limits

Other solved chains

Question about this chain, or a correction?