ADS-B 1090 MHz receiver, filter first: 4.99 dB NF

Antenna cable, SAW filter, LNA, feeder and SDR cascade to 4.99 dB NF and 44.0 dB gain. The 1.5 dB cable and the 2.5 dB SAW both land on the NF before the LNA's gain can help; the same parts with the LNA first read 2.65 dB.

Open in the analyzer

Change this: a 1.5 dB SAW in place of the 2.5 dB one. NF reads 3.99 dB, one for one, because the filter sits ahead of the LNA.

NF 4.99 dB: SAW band-pass 1090 MHz, 2.5 dB loss sets it, 1.86 dB better if ideal, 51% of the excess noise.

IIP3 14.00 dBm: LNA, NF 0.8 dB, 20 dB gain, OIP3 30 dBm is the only rated stage.

Block diagram

1090 MHzantenna, −85 dBmaircraftAntenna cable,1.5 dB lossSAW band-pass1090 MHz, 2.5 dBlossLNA, NF 0.8 dB,20 dB gain, OIP330 dBmCable toreceiver, 2 dBlossSDR receiver, NF6 dB, 30 dB gain

Level diagram

−150−100−50050100dBm1090 MHz anten…Antenna cable,…SAW band-pass …LNA, NF 0.8 dB…Cable to recei…SDR receiver, …
Carrier in channelNoise in channelCumulative OP1dBCumulative OIP3Output referred, after each block.

Budget at SDR receiver, NF 6 dB, 30 dB gain

RowValue
Cumulative Gain44.00 dB
Source Contribution−41.00 dBm
Cumulative NF4.99 dB
SNR20.98 dB
Noise Density−124.99 dBm/Hz
Total Noise Power−61.98 dBm
Noise Floor (Input)−105.98 dBm
P1dB Headroom88.00 dB
Cumulative OIP358.00 dBm
Cumulative IIP314.00 dBm
Cumulative OP1dB46.00 dBm
Cumulative IP1dB3.00 dBm
First Stage to Compress OP1dB46.00 dBm
SFDR79.98 dB
Linear Dynamic Range108.98 dB
IM3−239.00 dBm
Cumulative Noise + Distortion Ratio20.98 dB
Fully Linear Power−41.00 dBm
Local Compression0.00 dB
Cumulative Compression0.00 dB

Every number here is the analyzer's own, solved when the site was built from the same template the button opens. How the solver is checked.

ADS-B LNA first vs filter first: 2.33 dB better NF for 2.5 dB less P1dB headroom

Model limits

Other solved chains

Question about this chain, or a correction?