2-way Wilkinson power-combining PA at 2.2 GHz: 36.5 dBm out, OIP3 51.0 dBm
A driver, a Wilkinson splitter, two 38 dBm P1dB PA branches and a Wilkinson combiner put 36.5 dBm into the antenna load, 4.3 dB under cascaded P1dB. The combiner adds the in-phase branches as voltages, so two arms give 3 dB more than one, less the combiner's own loss.
Change this: branch B's phase trim from 0 to 30 degrees. Output reads 36.18 dBm, −0.30 dB, and the lost power goes to the combiner's isolation resistor.
This path runs through a combiner, so no single stage sets its NF or intercept; the analyzer leaves the What limits rows blank past a merge.
Block diagram
Level diagram
Budget at Tx Antenna Load
| Row | Value |
|---|---|
| Cumulative Gain | 44.62 dB |
| Source Contribution | 36.48 dBm |
| EIRP | 41.48 dBm |
| SNR | 76.77 dB |
| Noise Density | −113.30 dBm/Hz |
| Total Noise Power | −40.29 dBm |
| Output Noise Relative to Carrier | −149.78 dBc/Hz |
| P1dB Headroom | 4.31 dB |
| Cumulative OIP3 | 51.01 dBm |
| Cumulative IIP3 | 6.39 dBm |
| SFDR | 60.87 dB |
| IM3 | 7.41 dBm |
| Cumulative Noise + Distortion Ratio | 29.06 dB |
| Fully Linear Power | 36.62 dBm |
| Local Compression | 0.00 dB |
| Cumulative Compression | 0.14 dB |
Every number here is the analyzer's own, solved when the site was built from the same template the button opens. How the solver is checked.
Model limits
- The solver is unidirectional and matched: no mismatch interaction, return-loss cascade or stability.
- Noise density, NF, compression, gain and IM3 are read at each block's stage frequency, not solved across the operating band.
- Distortion is IM3 only, and IM3 is not frequency resolved.
- Compression is a memoryless AM/AM curve: no AM/PM, bias or memory effects. Noise keeps the small-signal gain under a blocker.
- A split and recombine of one source reads up to 10·log10(N) dB better in SNR than it should (3.0 dB for 2 arms), because noise ahead of the split is summed incoherently.
- Directional-coupler directivity is not a full reverse-isolation network.
Other solved chains
- 2.45 GHz superheterodyne receiver: 3.36 dB NF and −85.4 dBm sensitivity
- Direct-sampling SDR receiver at 1.2 GHz: 4.45 dB NF with 18.8 dB of ADC headroom
- LoRa 915 MHz receiver front end: 4.66 dB NF with an LNA after the filter
- ADS-B 1090 MHz receiver, filter first: 4.99 dB NF
- ADS-B 1090 MHz receiver, LNA first: 2.65 dB NF
- 2.4 GHz chip-antenna receiver: 8.00 dB NF and −94.0 dBm sensitivity
- 28 GHz 5G transmitter lineup: 44.5 dBm EIRP with 8.7 dB P1dB headroom
- Ka-band 28.5 GHz transmitter lineup: 57.1 dBm EIRP with 6.2 dB P1dB headroom